ASUS KGPE-D16 server/workstation board


Return to index

TODO: OLD page. TODO: check that all the info is still valid.

Introduction

This is a server board using AMD hardware (Fam10h and Fam15h CPUs available). It can also be used for building a high-powered workstation. Powered by Canoeboot. The coreboot port was done by Timothy Pearson of Raptor Engineering Inc. and, working with them (and sponsoring the work), merged into Libreboot (and inherited by Canoeboot).

Memory initialization is still problematic, for some modules. We recommend avoiding Kingston modules. For working configurations see https://www.coreboot.org/Board:asus/kgpe-d16.

Flashing instructions can be found at ../install/#flashprog - note that external flashing is required, if the proprietary (ASUS) firmware is currently installed. If you already have Canoeboot, by default it is possible to re-flash using software running in GNU+Linux on the KGPE-D16, without using external hardware.

CPU compatibility

Opteron 62xx and 63xx CPUs work just fine.

Board status (compatibility)

See https://raptorengineeringinc.com/coreboot/kgpe-d16-status.php.

Form factor

These boards use the SSI EEB 3.61 form factor; make sure that your case supports this. This form factor is similar to E-ATX in that the size is identical, but the position of the screws are different.

IPMI iKVM module add-on

Don’t use it. It uses proprietary firmware and adds a backdoor (remote out-of-band management chip, similar to the Intel Management Engine. Fortunately, the firmware is unsigned (possibly to replace) and physically separate from the mainboard since it’s on the add-on module, which you don’t have to install.

Flash chips

2MiB flash chips are included by default, on these boards. It’s on a P-DIP 8 slot (SPI chip). The flash chip can be upgraded to higher sizes: 4MiB, 8MiB or 16MiB. With at least 8MiB, you could feasibly fit a compressed linux+initramfs image (BusyBox+GNU+Linux system) into CBFS and boot that, loading it into memory.

Canoeboot has configs for 2, 4, 8 and 16 MiB flash chip sizes (default flash chip is 2MiB).

DO NOT hot-swap the chip with your bare hands. Use a P-DIP 8 chip extractor. These can be found online. See http://www.coreboot.org/Developer_Manual/Tools#Chip_removal_tools

This guide shows how to flash the chip:
25xx NOR flashing guide

Native graphics initialization

Only text-mode is known to work, but linux(kernel) can initialize the framebuffer display (if it has KMS - kernel mode setting).

Current issues

Hardware specifications

The information here is adapted, from the ASUS website.

Processor / system bus

Core logic

Memory compatibility (with Canoeboot)

Expansion slots

Form factor

ASUS features

Storage

Networking

Graphics

On board I/O

Back I/O ports

Environment

Monitoring

Note:

Markdown file for this page: https://canoeboot.org/docs/hardware/kgpe-d16.md

Subscribe to RSS for this site

Site map

This HTML page was generated by the Untitled Static Site Generator.